Modify TCP ports for snapmirror?

Question

My client has an application that uses some of the same TCP ports that Snapmirror uses.  Is it possible to change the ports that Snapmirror uses?  E.g. could Snapmirror run on ports 12000, 12104, and 12105 instead of the normal 10000, 11104, and 11105?  I don't see any evidence from the docs that it's possible, but ...

BradenP · Accepted Answer

It does not seem like you can. Looking at the doc below, page 16 where it talks about the firewall requirements, it does not state that you can change the TCP ports from the 10000, 11104, and 11105.

https://www.netapp.com/media/17229-tr4015.pdf?v=127202175503P

This KB mentions more of the same:

https://kb.netapp.com/Advice_and_Troubleshooting/Data_Protection_and_Security/SnapMirror/What_are_the_firewall_requirements_for_intercluster_SnapMirror_with_ONTAP_9