Subscribe

Deleting existing SAS aggregate and re-create it again.

Dear All,

I am new to Netapp Storage. We need to delete the existing SAS aggregate and re-create it from scratch. I want the details steps and/or documents where details steps will be there.

Please find the below basic details of SAS aggregate:-

volume aggr_sas_n1 (2 RAID groups):

        group 0: 20 disks

        group 1: 20 disks

volume aggr0_n1 (1 RAID group):

        group 0: 3 disks

This aggregate is 64-bit version.

Please help...thanks

Re: Deleting existing SAS aggregate and re-create it again.

So which aggregate you need to delete?

Re: Deleting existing SAS aggregate and re-create it again.

Thanks aborzenkov for your interest.

I want to delete below aggregate and re-create it with same configuration.

volume aggr_sas_n1 (2 RAID groups):

group 0: 20 disks

group 1: 20 disks

Regards,

Sabarna Deb

“skill, will and hill”

Re: Deleting existing SAS aggregate and re-create it again.

Ok, i'm confused.. Why are you deleting it if you are recreting it with the same configuration?

Re: Deleting existing SAS aggregate and re-create it again.

Because we got LUN ID conflict error for two SAS volumes due to some changes on the fly. We decided to delete the aggregate and re-create it.

Re: Deleting existing SAS aggregate and re-create it again.

What?  I'm still not seeing the entire picture.. You can assign a different lun id

Re: Deleting existing SAS aggregate and re-create it again.

Same LUN ID for two SAS volume.

Re: Deleting existing SAS aggregate and re-create it again.

Dude, your confusing me..  and scaring me in the same time...

But whatever here ya go

aggr offline (aggrname)

aggr destroy (aggrname)

then follow the aggregate create commands.

Re: Deleting existing SAS aggregate and re-create it again.

What do you call "SAS volumes"? Could you paste exact command and its output where you see them?

Re: Deleting existing SAS aggregate and re-create it again.

Volumes which we created from SAS disk therefore i called 'SAS volume'. Sorry I should not mention 'SAS'. Thanks JGPSHNTAP.....today i will follow the steps....