Community

Subscribe
Highlighted
Accepted Solution

Enable CPU monitoring after OCUM 5.2 upgrade

We just upgraded from OCUM 5.0.1 to 5.2. CPU percentage monitoring is disabled after upgrade. Any idea how I can re-enable this?

Re: Enable CPU monitoring after OCUM 5.2 upgrade

Hi Muhammad,

                   This is done due to the CPU monitoring became more of a false positive esp starting Data ONTAP 8.1 and later.

So by default we decided to disable it starting OCUM 5.2. The advise is to rather use the Performance Adviser alerts for better performance alerting.

linux-t5gs:~ #  dfm options list cpuMonInterval

Option          Value

--------------- ------------------------------

cpuMonInterval  Off

linux-t5gs:~ #

You can always go and turn this options ON as follows

linux-t5gs:~ # dfm options set cpuMonInterval=

Changed CPU monitoring interval to 5 minutes.

linux-t5gs:~ #

Regards

adai

Re: Enable CPU monitoring after OCUM 5.2 upgrade

From 5.2 the CPU monitor is disabled by default, the monitor can be enabled by running following command:

# dfm option set cpumoninterval=

You might consider setting it to a higher value that the default of 5 minutes to ensure you do not receive false alerts.

# dfm option set cpumoninterval=30m

There will be a public report here that describes this eventually:

http://support.netapp.com/NOW/cgi-bin/bol?Type=Detail&Display=612203

Re: Enable CPU monitoring after OCUM 5.2 upgrade

Nice on Adi. Thank you

Re: Enable CPU monitoring after OCUM 5.2 upgrade

Thank you for reply