Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Management Console no longer displays queue depth (system:pa_concurrency)
2011-09-28
02:23 PM
3,460 Views
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I had a custom view setup for queue depth (system:pa_concurrency). It was working fine and then we upgraded to On Command 5.0. Now the charts are blank and I get no data. Tried deleting and re-creating with no luck. I tried going to Setup - Hosts - and editing the data collection but when I look at system I don't see pa_concurrency (it is not listed as either disabled or enabled). Not sure if it is supposed to be there or not? Any help would be appreciated. Thanks! Jeff
3 REPLIES 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think I just found a clue. When I try to recreate the chart it shows pa_concurrency in italics (which means data collection is disabled). So that is why I have no data. Now.....to figure out how to turn it on since I did not see it as an option the last time I looked.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Counter "pa_concurrency" is a calculate stat counter, this counter value calculated using below counters.So, please make sure that perf data collection is enabled for below counters.
nfsv3_avg_op_latency
nfsv3_ops
nfsv4_avg_latency
nfsv4_ops
cifs_latency
cifs_ops
iscsi_read_latency
iscsi_read_ops
iscsi_write_latency
iscsi_write_ops
fcp_read_latency
fcp_read_ops
fcp_write_latency
fcp_write_ops
Regards,
Gireesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Gireesh,
I have confirmed that Performance Advisor is collecting all of the counters you listed. However, when I attempt to add the pa_concurrency counter to a chart, its still shown in italics. When I move my mouse over the counter it states "...(Data collection currently disabled).". What am I missing that enables the pa_concurrency counter in OnCommand 5.0? My controllers are all ONTAP 8.1RC2.