No, that's not possible. You can either use VSM (any reason you do not?) or arrange data in qtree on source as well.
Отправлено с iPhone
26.09.2013, в 0:07, "TMADOCTHOMAS" <firstname.lastname@example.org<mailto:email@example.com>> написал(а):
Re: Replicating a Qtree to a Volume
created by TMADOCTHOMAS<https://communities.netapp.com/people/TMADOCTHOMAS> in Data ONTAP - View the full discussion<https://communities.netapp.com/message/117340#117340>
Thanks for replying aborzenkov. The scenario is this: we use volume-to-qtree snapmirror to replicate volumes from 2220's in our remote offices to qtrees on our 3270 at headquarters. In the event of a disaster, we would make the qtrees on the 3270 read-write and use them until a new 2220 was available. Then we would need to migrate the qtrees back to volumes on the new 2220. I'm trying to determine the best plan to migrate the qtrees to volumes on a new 2220. I see what you mean that we could share out both sides and use standard Windows copy commands, but I was hoping there was a snapmirror option.
Reply to this message by replying to this email -or- go to the message on NetApp Community<https://communities.netapp.com/message/117340#117340>
Start a new discussion in Data ONTAP by email<mailto:firstname.lastname@example.org> or at NetApp Community<https://communities.netapp.com/choose-container.jspa?contentType=1&containerType=14&container=2877>