Network and Storage Protocols

SnapDrive / Create Disk / without CIFS?

igor
2,866 Views

Hi, all!

I was wondering if it is at all possible to use SnapDrive's Create Disk functionality without using CIFS? The Installation Guide states this to be the correct procedure:


In the “Enter a Virtual Disk UNC Path to Storage System Volume or Qtree” field, type the storage system location for the LUN (\\storage1\vol1, for example). Alternatively, click Browse and navigate to that location.

This doesn't work. As I found out later on, the UNC path needs to point to a share, not a volume, located on a filer that is a part of a domain. How can this be accomplished without a CIFS licence?

Igor

1 ACCEPTED SOLUTION

radek_kubka
2,866 Views

You definitely don't need CIFS licence to use SnapDrive:

http://now.netapp.com/NOW/knowledge/docs/snapdrive/relsnap61/html/software/admin/GUID-F60C5199-3992-4558-A505-5F5B8ACA8465.html

Note: The iSCSI and FC licenses supplied with SnapDrive enable all the CIFS functionality necessary for using SnapDrive with the RPC transport protocol.

Regards,
Radek

View solution in original post

5 REPLIES 5

radek_kubka
2,867 Views

You definitely don't need CIFS licence to use SnapDrive:

http://now.netapp.com/NOW/knowledge/docs/snapdrive/relsnap61/html/software/admin/GUID-F60C5199-3992-4558-A505-5F5B8ACA8465.html

Note: The iSCSI and FC licenses supplied with SnapDrive enable all the CIFS functionality necessary for using SnapDrive with the RPC transport protocol.

Regards,
Radek

igor
2,867 Views

Thanx, Radek! It's states the same for previous versions (namely, 5.0.1) in the Installation Guide. Small print. 😃

satishv
2,866 Views

I think this is the case with older versions of Snapdrive.

The current versions don't have a dependency on CIFS.

They can work with HTTP/HTTPS or even without having to create a CIFS share.

tom_dewit
2,866 Views

In the older snapdrive versions, CIFS was indeed the only protocol you could use to connect or create disks with snapdrive. You didn't need a CIFS license for that on the filer, just enable cifs without a license installed. NetApp allows you to create administration shares for Snapdrive without the license. Be warned that every CIFS access to the filer by Snapdrive will create a syslog entry saying you don't have a CIFS license installed. You can savely ignore them however.

In later versions of Snapdrive (since 6.0 I think) you can use RPC or HTTP to connect to the filer, which is much easier because you don't need to make CIFS shares anymore to make snapdrive work.

Grtz,

Tom

igor
2,867 Views

Thanx for the advice guys,

I'll test it out with a simulator and see how it goes.

Cheers!

Igor

Public