AFF

E2760 How do you get into the CLI serial port using putty.

Scott_G
3,962 Views

Does anyone have the settings for putty for the serial connection and the key sequense to get into DIAGS to reinit the array? 

1 ACCEPTED SOLUTION

Mulya
3,924 Views

Hi @Scott_G , 

 

Assuming you are using putty in your laptop, please use the following

Connection type: Serial

Speed: 115200

Serial Line: your laptop COM port

 

Thank you,

Mulya

View solution in original post

4 REPLIES 4

Mulya
3,925 Views

Hi @Scott_G , 

 

Assuming you are using putty in your laptop, please use the following

Connection type: Serial

Speed: 115200

Serial Line: your laptop COM port

 

Thank you,

Mulya

pedro_rocha
3,923 Views

Do you have an active support contract with NetApp?

 

"SSH is not a supported management protocol for E-Series devices. To manage the storage array, there is SANtricity for GUI based management or SMcli for the command line.

For support procedures, occasional Telnet or SSH access is required. However, it is not possible to use Telnet/SSH for day-to-day operations."
 
Nevertheless, I would try: default all and 115200 or 9600
 

Scott_G
3,883 Views

Thanks for the reply. Yes, 115200 is the baud rate. I was trying to get into the Service level CLI with is a key sequence when you login thru the serial port. I figured out.  Thxs!

ExactLabSysAdmin
3,578 Views

Hi Scott_G,

I guess you used a mini-usb to rs232 cable. Can you share the cable part-number?

And how did you get into the Service level CLI?

Thanks.

Public