Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All,
Wondering if this is a configuration issue or a limitation of the software.
I have both OnCommand 5 and OnCommand System Manager 2.0 installed and running and as far as I was aware they were both running 100%.
In the last couple of days I have had a fault on one of our DS14 ATA shelves.
Errors are appearing on the console as
[XX-XXX: monitor.shelf.fault:CRITICAL]: Fault reported on disk storage shelf attached to channel 4c. Please check fans, power supplies, disks, and temperature sensors.critical
and under Filer view - the status for the controller shows a "Disk shelf fault"
Both OnCommand and System Manager show the controllers as "Green" or "Up".
So have I missed something in my configuration of both these new tools or do they not report "Hardware Faults"
Regards,
Richard
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Richard,
Can you check for the below event for the controller, whose disk shelf is failed.
dfm report view events <Controller Name> and check for the event "enclosures-failed",
Also the controller will not be shown as down for the disk shelf failrues, but the status should be shown as Error.
Which ONTAP version you are running in the filer?
-KJag
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi KJag,
dfm report view events is only listing "information" events
Running ONTAP 7.3.5.1
Regards,
Richard
