Data Backup and Recovery

how to access snapvault snapshot on SVM-DR destination

FelixZhou
2,025 Views

we have configured SVM snapmirror and will have a need to restore data from snapvault snapshots. Since we used SVM snapmirror, the destination SVM is offline. when we need to access snapvault snapshot, currently we will create a flexclone to a test SVM to access the snapshot. We have many snapshots and not sure where is the data located. is there any way we can access to all snapshots on destination at same time for data browser and search?

thanks in advance

1 ACCEPTED SOLUTION

aladd
1,842 Views

With SVM-DR setup, this won't be feasible because the destination vserver has to be in an offline RO state for the configuration.

 

in a traditional XDP relationship, you would be able to create a share or mount point on the destination vserver to access the volumes attached to that vserver, in order to access the RO destination volumes.

View solution in original post

5 REPLIES 5

FelixZhou
1,855 Views

thanks for reply. Actually we are looking for a way to access all snapshots together on the SVM-DR destination when SVM is offline. let us say we have 60 snapshot on SVM snapmirror destination, we don't where is the data located, we know we can Flexclone snapshot by snapshot to search the data. But is there any way to access all snapshots at one shot?

thanks,

aladd
1,843 Views

With SVM-DR setup, this won't be feasible because the destination vserver has to be in an offline RO state for the configuration.

 

in a traditional XDP relationship, you would be able to create a share or mount point on the destination vserver to access the volumes attached to that vserver, in order to access the RO destination volumes.

FelixZhou
1,614 Views

great idea. this is what i am looking for. i will test it out.

thanks for your sharing.

ansley_tj
1,616 Views

@FelixZhou, To be able to access the Snapshot copies within the destination SVM of an active SVM-DR relationship you can use -identity-preserve false parameter when you setup your SVM-DR relationship. With this parameter you can start the destination SVM using vserver start <svm-name> command and you should be able to access the R/O DP volumes and their snapshots.

 

If you want self-service for your users, you will have to do the above and then create a new NAS identity for your users to mount.

 

Note: this will mean that the source SVM's NAS(NFS/CIFS export policies/shares, etc) and network (IP addresses, etc) configuration information will not be transferred and in the event of a needed failover to the destination, you will have to reconfigure the network settings of the destination SVM to those that were used by the source SVM (or reconfigure your clients...though reconfiguring the destination SVM will probably be simpler and faster 😀)

 

Thanks
Tony Ansley
I am a NetApp employee.
Public