Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi folks, first time setup of altavault appliance. I'm not sure how to designate an interface as the replication interface in AVA-400. I have a primary interface w/ default route. a 10G interface to my backup servers. also configured one of the 1G interfaces with a default route and thought that would be the replication interface, but all my backend traffic is going through the primary interface. have searched the docs for a day and half now and can't glean how to designate the 1G interface as my replication interface so it sends the cloud traffic via that interface.
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
sorry about the bogus label, i didn't see one that applied... so here is the relevant config, which i thought meant the backend traffic would traverse the e0i interface.
ip data-gateway e0i "10.x.x.x" <--- indicating a default route for the backend, but perhaps i'm miss understanding something
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The settings for this can be found under Configure > Cloud settings > Bandwidth tab > Cloud Replication Interface.
