2018-04-18 02:52 PM
This is the only place it is letting me post this question. But I have an older E2600 Array. I have a cache battery that needs to replaced in one of my controllers. I need to mute the alarm. If I hit the button on the unit, it will just mute for 1 seconds and start up again. I have searched through the entire Santricity application, and the manual. It doesn't show you how to mute this thing until you get a replacement battery.
2018-04-24 07:21 AM
@harveypny I believe that the alarm configuration can be found on the hardware tab of the SANtricity Storage Manager application. As I recall, it can be setup on a per-controller basis. You can click to view individual hardware components, and I believe that the alarms and their settings can be found there. Unfortunately, I do not have an older system that I can verify this with right now. Let me know if you are able to locate the alarm settings based on these instructions.
2018-05-16 04:10 AM
What would be nice, if I could tell it stop checking for the battery every 1 min. Because if you supress the alarm on the front, the next min it starts beeping again. So someone would need to press the button every minute to stop the alarm. I wish I could tell the array to check once a day or something until we replace the battery.