Legacy Product Discussions

Highlighted

Can NOT Access 6280 by url

Hi -

I am unable to access my FAS6280 by webpage.

I ran httpd options and here is the following output:

httpd.access                 legacy
httpd.admin.access           legacy
httpd.admin.enable           on
httpd.admin.hostsequiv.enable off
httpd.admin.max_connections  512
httpd.admin.ssl.enable       on
httpd.admin.top-page.authentication on
httpd.autoindex.enable       off
httpd.bypass_traverse_checking off
httpd.enable                 on
httpd.log.format             common     (value might be overwritten in takeover)
httpd.method.trace.enable    off
httpd.rootdir                /vol/vol0/home/http
httpd.timeout                300        (value might be overwritten in takeover)
httpd.timewait.enable        off        (value might be overwritten in takeover)
mysanfiler>

any reason why it should not ? Also how can i resolve this so I can.. ? thanks much

ONTAP version:NetApp Release 8.0.1 7-Mode: Wed Jan  5 17:23:51 PST 2011

4 REPLIES 4
Highlighted

Re: Can NOT Access 6280 by url

Hi,

What is the URL you are using?

http://filername/na_admin?

Highlighted

Re: Can NOT Access 6280 by url

That's correct. I am using that url and a variation of https as well.

Highlighted

Re: Can NOT Access 6280 by url

In some cases (not often) but if the system were zeroed and booted for example, the ONTAP files are not all on disk (or there is a missing file or corruption or permissions issue), so downloading ONTAP again can fix this...  In other cases if the root volume was moved sometimes ssl breaks.

If you rerun ssl setup   (secureadmin disable ssl, secureadmin setup -f ssl, secureadmin enable ssl), does that fix it?  If not, does pushing ontap again (software update imagename.tgz -r) fix it?

Highlighted

Re: Can NOT Access 6280 by url

Folks - I just realized that after the intiial rack and stack of the equipment  only the management connections (Service processor) were setup, which does not support FilerView rather command line only.

appreciate the replies...

Check out the KB!
NetApp Insights To Action
All Community Forums