OverProvisioningPercent and TotalLunSize values are "0" ?

[#1]

Hi all ,

When I checked the "OverProvisioningPercent and TotalLunSize" values of "Get-NaEfficiency volume" output  , I see "0"

- TotalLunSize:  Total size of all the LUNs contained within this volume.  This value is only valid when the -Recurse switch is present.

- OverProvisioningPercent: The LUN over-provisioning percent of the volume.  This value is equal to (TotalLunSize / Capacity) * 100.  This value is only valid when the -Recurse switch is present.

volume size is : 4GB (thin)

lun1 size is : 10GB (thin)

lun2 size is : 3GB (thick)

But , "TotalLunSize" and "OverProvisioningPercent" values are "0"

is it normal ?

ontap version : 7.3.7

powershell version : 4.2

[#2]

Hello @tsener,

This is almost certainly because you're using ONTAP 7.3.7, a very old version which is not supported by the PowerShell Toolkit (PSTK).  You might be able to manually calculate the values using the PSTK (I did something similar here), but there's no guarantee any of the cmdlets will work as expected with ONTAP 7.

Andrew

[#3]

Hi asulliva ,

I have tried same commands at ontap 8.2 (7-mode) .But I receive same errors . (value is still "0")

[#4 · Accepted solution]

I don't have a 7-mode system to test against at the moment, but, just to be sure, are you using the "-Recurse" option?

Get-NaEfficiency -Volume MyVol -Recurse

Andrew

[#5]

thank you asulliva