Network and Storage Protocols

Failover Monitor: CIFS: Giveback cancelled due to active state

ASRARGUNA
19,377 Views

Hello All,

I have 2 filers in HA pair Filer-1 and Filer-2. On Filer-1, i did cf takeover and it tookover Filer-2 fine. Now when I am trying to do cf giveback on Filer-1, it gives error:

Filer-1(takeover)> [Filer-1:cf.misc.operatorGiveback:info]: Failover monitor: giveback initiated by operator 

Wed Aug 28 17:47:38 AST [Filer-2:cifs.terminationFailed:error]: CIFS: CIFS did not shut down: There are CIFS users with open files on the partner node.  All CIFS sessions for the partner node must be closed prior to giveback. 

Wed Aug 28 17:47:38 AST [Filer-1:cf.rsrc.givebackVeto:error]: Failover monitor: cifs: giveback cancelled due to active state 

Wed Aug 28 17:47:38 AST [Filer-1:cf.fm.givebackCancelled:warning]: Failover monitor: giveback cancelled

I did cifs terminate on filer-1 and it stopped CIFS service but cf giveback doesn't work at all. Same error as above. That is because CIFS is running on Filer-2. How can I stop that? Shell is not supported on takeover partner!

Should I do Filer-1 (takeover)> cifs giveback -f

If i use cifs giveback -f, will there be any risk?

I would really appreciate any response.

Thanks - AG

1 ACCEPTED SOLUTION

billshaffer
19,377 Views

You can do a giveback -f, but I don't like doing so because if there are other issues you're unaware of, -f will override them, too - though I'm sure plenty of people will say that -f is fine.

In takeover mode, on the node that has taken over the partner, you can issue the "partner" command.  This puts you into a virtual shell on the node that was taken over.  The prompt will say something like "filer1 (filer2)>".  This is where you should do the cifs terminate.  Then issue "partner" again, and it will bring you back to the other node.

Bill

View solution in original post

6 REPLIES 6

billshaffer
19,378 Views

You can do a giveback -f, but I don't like doing so because if there are other issues you're unaware of, -f will override them, too - though I'm sure plenty of people will say that -f is fine.

In takeover mode, on the node that has taken over the partner, you can issue the "partner" command.  This puts you into a virtual shell on the node that was taken over.  The prompt will say something like "filer1 (filer2)>".  This is where you should do the cifs terminate.  Then issue "partner" again, and it will bring you back to the other node.

Bill

ASRARGUNA
19,376 Views

Bill, You my friend are a STAR

Thank You - AG

shashii82
13,903 Views

Thank you Bill for the brief explanation and commands. It worked like a charm.

DanKadam
10,766 Views

Thanks BIll it worked perfect

partner on the taken over node

then cifs terminate ----it tokk 3-4 extra minutes have patience

cf giveback

AMG
6,942 Views

Thank you!!

NagarajuKankipati
280 Views

This just worked like a charm, Bill.

 

Thanks

Nag.

Public