You may wish to use your NOW login -> Downloads -> Software -> (http://support.netapp.com/NOW/cgi-bin/software/)
Depending on your protocol, you may pick FC Host Utilities or iSCSI Host Utilities
Don't forget Multipath as well
Good luck & Good Saturday
For Linux I use the native MPIO tools that the operating system provides, with the exception of Windows prior to 2008. (We can use either native or our own MPIO plugin with Windows 2008 and greater)
The Linux version is called DM-MPIO and should be present in all modern Linux distributions. You should check the NetApp Interoperability Matrix to make sure the RHL system, FCP cards, etc., are supported by NA.
Take a look at the link below:
Good luck & Happy Saturday
I am using iscsi, not fc
I have iscsi-initiator-utils on Linux, but how do I know I am really using it?
I have done with setting up luns on Linux server, however, the performance is very very slow. I use luns for Oracle ASM disks.
Ohh, its ok, If you are using iscsi then you can download this under iscsi host utility DOWNLOAD > iSCSI Host Utilities.
for linux the iscsi package is comming by default.
what is the speed for your eth card on host?
i have 1Gbit eth card. There are not too much I/O at all, this is just test server, and small DB. it took more than 12 hours for things usually only took about less than half hour. Are there anything I can tune?
Thanks for your message
Please go through the below link. this will guide you how to tune for iscsi.
Please check your jumbo frame setting for your eth.
Good Morning Please I would like to setup a windows host utilities for the DS4243 and any document that can allow me to easily configure,
in the download section on the website is not giving me permissions to download
your support will be a great help to me thank you in advance