NetApp Community Update
This site will enter Read Only mode on July 23 as we prepare to move to a new platform. You will still be able to view content, but posting and replying will be temporarily disabled. We're excited to launch our new Community experience on July 30 and more information will follow soon. Stay connected during the transition - Join our Discord community today.
Legacy Product Discussions (RO)
About Legacy Product Discussions (RO)
Are you keeping it old school with a NetApp relic no longer officially supported by NetApp? Discuss end of support (EOS) hardware and software such as StoreVault, Data ONTAP 6, DataFort and older FAS models here.
This space is fully community supported. NetApp does not actively monitor this area.
Are you keeping it old school with a NetApp relic no longer officially supported by NetApp? Discuss end of support (EOS) hardware and software such as StoreVault, Data ONTAP 6, DataFort and older FAS models here.
This space is fully community supported. NetApp does not actively monitor this area.
Hello, Requires data ontap 7 version and ontap 8.0,8.1 version. Until recently, the software had access to the software download page. Did something change?
... View more
Is the Netapp Shift software, which allows conversion from one hypervisor type to another, still an active supported project. If it is, we wanted to investigate it's capabilities.
... View more
We're running DOT 8.2 7-Mode on our IBM N-Series N6240 and recently had the motherboard in node A replaced. Problem is the replacement motherboard is running service processor 1.3P1, which is not supported in 8.2: http://www-01.ibm.com/support/docview.wss?uid=ssg1S7004436
How can we upgrade the service processor to 1.4 while running in failover mode? I tried doing 'sp setup' from LOADER A screen and the configuration won't stick (shows 'unknown' configuration).
... View more
I would like to upgrade my IBM N Series N3700 (NetApp FAS270 equivalent) from 7.1.1.1 to 7.3.7.
I realize that support is discontinued on these products but I was able to download the n series OnTap 7.3.7 code from the IBM support site and a decent set of documentation including an upgrade guide. The only thing is that there is no explanation about the contents of the download:
I don't know which file to use in the "software install ..." command. My hunch is one fo the .exe files but what is the diferenece between the three different ones?
I've extracted the _e setup archive and this created a series of folders presumably with the update code and routines in addition to the bundled firmware updates. Is there a file here that I need to use in the "software install..." command?
I know that this is a NetApp forum but IBM has been of zero help in providing this information. I would presume that the NetApp code comes in a similar bundle. Your help is appreciated in advance.
... View more
