OnTAP Select - system controller show

[vemus]

Hi Team,
we are planning to add controller support for NetApp SP Controller

Command: system controller show -instance

Below is the sample response for NetApp Ontap

-----------------------------------------------------------------

netapp-c1::> system controller show -instance

Node: netapp-xxx

System ID: xxx

Model Name: AFF-A250

Part Number: xxx

Revision: A6

Serial Number: xxx

Controller Type: none

Status: ok

Chassis ID: xxx

Node: netapp-xxx

System ID: xxx

Model Name: AFF-A250

Part Number: xxx

Revision: A6

Serial Number: xxx

Controller Type: none

Status: ok

Chassis ID: xxx

2 entries were displayed.

-----------------------------------------------------------------

But for ONTAP SELECT array, unable to get the data seeing the below error

-----------------------------------------------------------------

OnTapMulti::> system controller show -instance

Error: show failed: RPC: Program not registered [from mgwd on node "OnTapMulti-01" (VSID: -1) to nphm at 127.0.0.1]

-----------------------------------------------------------------

Can anyone pls help us to understand this

Is controller command support for ONTAP SELECT? or Do we need to do any configuration changes to get controller data for ONTAP SELECT? Could you please help us to understand this more ?

[cedric_renauld]

Hello

Th e "hardware" config for select is managed by the deploy VM, if you want to know witch conf you haev you need to connect to depoloy system and extract the HW conf / licence

[vemus]

I didnt get the answer, could you please explain it more.

one question i have

is ONTAP Select supports system controller show command or not?

Do we have any doc related to this. could you please share if any.

Thanks in Advance