ONTAP Discussions

Recovered error predictive failure alert on disk

ark

While initializing the NetApp cluster, they run clean configuration and setup advanced partitioning.  Its running ... running and running after 6 hours even the same message is repeating as below.

 

Can anyone help what we can do, shall we terminate the process and re-do?

 

"May 01 02:32:23 [localhost:disk.ioRecoveredError.pfa:error]: Recovered error predictidisk 1c.13.6: op 0x28:00000008:0008 sector 9 SCSI:recovered error - Disk reports predicted failure even
calhost:disk.ioRecoveredError.pfa:error]: Recovered error predictive failure alert on disk 1c.13.6: op ector 9 SCSI:recovered error - Disk reports predicted failure event (1 5d 89 74)
calhost:disk.ioRecoveredError.pfa:error]: Recovered error predictive failure alert on disk 1c.13.6: op ector 9 SCSI:recovered error - Disk reports predicted failure event (1 5d 89 74)
calhost:disk.ioRecoveredError.pfa:error]: Recovered error predictive failure alert on disk 1c.13.6: op ector 9 SCSI:recovered error - Disk reports predicted failure event (1 5d 89 74)
May 01 06:32:27 [localhost:disk.ioRecoveredError.pfa:error]: Recovered error predictive failure alert on disk 1c.13.6: op 0x28:00000008:0008 sector 9 SCSI:recovered error - Disk reports predicted failure event (1 5d 89 74)"

Techarkit
3 REPLIES 3

Re: Recovered error predictive failure alert on disk

akiendl

The error means that there are some bad blocks on the disk. Nothing to worry about as disks have some "reserve" blocks that they will use instead.

If ONTAP sees too many of these errors or the disks runs out of alternate blocks the drive will be failed.

 

ak.

View solution in original post

Re: Recovered error predictive failure alert on disk

paul_stejskal

I would make sure your disk drive firmware is up to date: https://mysupport.netapp.com/site/downloads/firmware/disk-drive-firmware

Also wouldn't hurt to get shelf firmware. if you update to the most recent ONTAP it will come bundled with the drive firmware as well.

Re: Recovered error predictive failure alert on disk

ark

Thanks for all the replies.

We run the "clean configuration and initialize all the disks", out of the disks one of the disks was about to fail and it failed after 7 hours.

Then disk initialization was completed faster. We waited 8 hours to complete the task.

Techarkit
Earn Rewards for Your Review!
GPI Review Banner
All Community Forums
Public