ONTAP Discussions

ontap Update

weiliu
203 Views

Hello, everyone.
I encountered some problems in the process of upgrading the microcode of the storage. During the upgrade, after I initiated the takeover, the storage did not restart as expected. However, after the restart and loading, the storage was loaded into the LOADER, and then I checked the takeover status on the peer controller.
In this case, can I use "boot_ontap" to start this controller?
What is the cause of this problem? 

8a3887c149e712f00df4f3d200a5460.png

1 REPLY 1

SpindleNinja
189 Views

You can try to run it, but I would open a case though and have the logs reviewed.  

Public