ONTAP Hardware

Disk Replacement

MJABER
12,435 Views

Dear all , 

 

i am new to netapp community and i have queastion regarding disk replement , i got one disk failed and i need to replace , both disk are the same specification but the new one doesnt have any sticker as the old one from Netapp .

 

is this could be an issue ?

 

i have also tried to replace the disk and still show the amber light?

 

Thanks 

9 REPLIES 9

xavierpitz
12,348 Views

Hello,

 

How can you be sure that the specs from the "new" disk are the same if the label is missing ?

Can you have a look at a "aggr status -f" output and the "rdfile /etc/messages" output during the time you removed the old disk and replaced it with the new one ?

 

Xavier

MJABER
12,342 Views

 

 

xavierpitz
12,311 Views

Do you still see any failed disk when you look at the :

"aggr status -f"

output ?

 

Do you see the "new" disk as new spare with :

"aggr status -s"

?

MJABER
12,274 Views

i have attched the two disk picture 

 

the one with no lables is the new one which is not working or giving the amber light 

ONLY150_321
12,234 Views

Hi, 

your spare disk is not a Netapp spare part. You can see it at the FW. Netapp FW is NA02 (NAxx).

MJABER
12,220 Views

hi ,

 

thanks for your reply , so if i did disk firmware will solve the issue ?

 

 

ONLY150_321
12,169 Views

the system cannot work with this disk, normally it´s not possible to add Netapp FW on a disk with other FW

ismopuuronen
12,292 Views

Hi,

In CDOT it could be that the new disk is unowned and thats why the led is abmer after replacement.
CLI:
> system node run * disk show -n
> system node run * vol status -f

Br,
Ismo

MJABER
12,276 Views

i have attached the picture of two disk i have 

 

 

the one with no lables is the new one which is not working when replaced 

 

any advice ,,,

Public