An account will enable you to access:
Don't have an account?
I am currently getting an error on 2 FAS3040 filers that I pulled out of storage in our datacenter. I have hooked each up seperately to a disk shelf with esh4.Not sure what the error message means since I haven't seen this one before.Hopefully someone has some insight on what is wrong/ I am doing wrong. Below is the boot process up to the point of error.Phoenix TrustedCore(tm) ServerCopyright 1985-2004 Phoenix Technologies Ltd.All Rights ReservedBIOS version: 2.1.0Portions Copyright (c) 2006 Network Appliance, Inc. All Rights ReservedCPU= AMD Opteron(tm) Processor 250 X 2Testing RAM512MB RAM tested4096MB RAM installedBoot Loader version 1.2.3Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.Portions Copyright (C) 2002-2006 Network Appliance Inc.Error: DRQ should be zero
I am getting the same error on a cluster node that I have just replaced the system board on. Did you ever
get this resolved?
Here’s a video that explains how to use the Volume Recovery Queue
Join our Discord Community