ONTAP Hardware

FAS factory default

tclark
4,196 Views

I'm trying to reset an FAS 2520 to factory default but I can't see the device boot sequence in order to press CTRL C. I'm using putty with a KeySpan high speed USB to serial adaptor. It connects with com4 but never prompts to login and I can't see anything happening during power up. Once it's up I have no trouble getting in by SSH. Any ideas?

 

4 REPLIES 4

aborzenkov
4,189 Views
You can access console via SP session (system console).

tclark
4,186 Views

I'm not familiar with how to do that. Can that be done via putty?

aborzenkov
4,141 Views
Yes. You need to setup SP IP address (that is normally done from within running Data ONTAP) and then connect with SSH to this address. Physical connectivity is over wrench port.

Naveenpusuluru
4,075 Views

Hi @tclark

 

Please use the below command to check the SP ip.

 

 system service-processor show

 

 

You can use the service processor to connect to the console remotely.

Public