FAS3210 Power down and Power on procedures via SP

[RATNATHURAI]

I need to shutdown FAS3210 for a day and looking for the steps. I read few posts saying that cf disable and halt will shutdown via ssh.

What are the procedures to shutdown via SP console?

[SeanHatfield]

From the SP, use the "system console" command to connect to the console, then log into ONTAP.  From there the process is the same as it would be over ssh.  

7-mode (repeat on each controller):

halt -f

cDOT (halts the entire cluster):

halt * -inhibit-takeover true -skip-lif-migration-before-shutdown true -ignore-quorum-warnings true

That should leave the systems at the LOADER prompt.  After the maintenance event if its still sitting at the loader:

boot_ontap

Repeat on each node, wait for things to settle, then run config advisor to check for anything unexpected.