ONTAP Hardware

Gateway for VLAN interfaces

ZelChief
3,016 Views

Hello!

 

How to configure gateway for VLAN interfaces? Found information about default gateway https://kb.netapp.com/app/answers/answer_view/a_id/1034563/~/how-to-change-the-default-gateway-to-a-new-gateway- but cant't find any information about configuration gateway for VLAN interfaces. 

1 ACCEPTED SOLUTION

Ontapforrum
2,953 Views

Hi,

 

I am bit out-of-touch with 7-mode stuff, but as I remember, the routing table uses the default route when no other known route exists for a given packet's. But, you can add static route to for the destination using the following command.

 

How to use the route add command
https://kb.netapp.com/app/answers/answer_view/a_id/1034525


To add a route to the 10.17.250.0/24 (or whatever destination) network via 10.17.250.1, use the following syntax, using the proper value for the metric:


filer> route add net 10.17.250.0/24 10.17.250.1 1

 

Put that command in /etc/rc, else you will lose this route on a reboot. /etc/rc gets read at boot and sets up your network settings.

steps:
filer>rdfile /etc/rc
Copy all the text that it outputs, past it in a notepad, add the above command below the route add default, and write it back.
filer>wrfile /etc/rc
paste the edited notepad stuff.


This command overwrites the file with everything you enter at this point.

 

Thanks!

 

View solution in original post

1 REPLY 1

Ontapforrum
2,954 Views

Hi,

 

I am bit out-of-touch with 7-mode stuff, but as I remember, the routing table uses the default route when no other known route exists for a given packet's. But, you can add static route to for the destination using the following command.

 

How to use the route add command
https://kb.netapp.com/app/answers/answer_view/a_id/1034525


To add a route to the 10.17.250.0/24 (or whatever destination) network via 10.17.250.1, use the following syntax, using the proper value for the metric:


filer> route add net 10.17.250.0/24 10.17.250.1 1

 

Put that command in /etc/rc, else you will lose this route on a reboot. /etc/rc gets read at boot and sets up your network settings.

steps:
filer>rdfile /etc/rc
Copy all the text that it outputs, past it in a notepad, add the above command below the route add default, and write it back.
filer>wrfile /etc/rc
paste the edited notepad stuff.


This command overwrites the file with everything you enter at this point.

 

Thanks!

 

Public