ONTAP Hardware

How to Format the drives on a netapp FAS 8020 Filer

chrmar6414
3,516 Views

Hi,

 

I just installed a SAS Shelve from an FAS 3100 Filer to our new FAS 8020 Cluster. I need some suggestion on how I can format the data from the old Filer? Does I need to use the Disk Sanitazion command?  Here is a list of the SAS Disk:

 

data 1d.01.23 1d 1 23 SA:B - SAS 15000 560000/1146880000 560208/1147307688
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
Raid group is missing 15 disks.

RAID group /aggr4/plex0/rg1 (partial, block checksums)

RAID Disk Device HA SHELF BAY CHAN Pool Type RPM Used (MB/blks) Phys (MB/blks)
--------- ------ ------------- ---- ---- ---- ----- -------------- --------------
dparity FAILED N/A 560000/ -
parity FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data FAILED N/A 560000/ -
data 1d.01.22 1d ? ? SA:A - SAS 15000 560000/1146880000 560208/1147307688
Raid group is missing 6 disks.

1 ACCEPTED SOLUTION

shatfield
3,504 Views
There is a procedure to recover from that scenario. It involves setting a hidden option to reenable the aggr destroy command in the nodeshell.

Try KB 1013046

View solution in original post

4 REPLIES 4

shatfield
3,510 Views
Plug them back into the 3100, delete the aggrs, and remove disk ownership. Then move them to the new cluster.

chrmar6414
3,507 Views

Unfortunatly the Disk Shelve is on another site were the old Filer currently at. To do that, I will very much take out the either the old filer or the shelve of disk to there respective sites.

shatfield
3,505 Views
There is a procedure to recover from that scenario. It involves setting a hidden option to reenable the aggr destroy command in the nodeshell.

Try KB 1013046

chrmar6414
3,463 Views

Thanks for the Article. I was able to delete the Foreign Aggregates by following all the steps on the KB.

Public