ONTAP Hardware

Re: How to access NetApps Configuration in order to enable the disabled network interfaces

oamc_muscat
5,504 Views

OOOK

though im sure how to do it but i will try these things tomorrow as its already midnight here and office is closed.

i dont have experiance in using ftp as well how to do it ??!!!

we will resume work after 9 hours and i will let you know at that time

millions of thanks

5 REPLIES 5

oamc_muscat
5,504 Views

hey there,

i connected the rs232 cable and configured hyperterminal, but when i lauch it nothing appears only blank white space !!

can anyone assist

danielpr
5,504 Views

Hi,

Have you set the baud rate to  9600 on the hyper terminal ?

Thanks

Daniel

lwei
5,504 Views

As Daniel pointed out, you need to set baud rate to 9600. I took a screen shot of hyper term (attached). Make sure you pick the correct COM port too,

Thanks,

Wei

oamc_muscat
5,504 Views

Thanks Wei, Daniel,,

sorry i was a way for the last two hours. well after i posted my last question i did something to make sure from the connection. i turned off the netapps and obsereved the console then i swithed it on and logged in. then i search for the command in order to up the virtual interface and i did it. its working fine now.

again millions of thanks to you people and i wish i will be an expert in these things like you.

regards

lwei
5,504 Views

You are welcome. Glad it worked!   -Wei

Public