configuring trunk mode betweenAFF 300 and switch 6513

[joao2019]

Hi guys
I am trying to configure the trunk mode between a300 storage and Cisco Catalyst switch. and doesn't work

On the storage side, I created:
Ifgrp (two ports) -> vlan () -> Lif
Note: When I create Lif, it doesn't ping

On the side switch, I configured two ports as a trunk mode and stop allowing all vlans to pass
Note: if I configure the two ports on the switch in access mode they work perfectly. Only in trunk mode that does not work.

                                     info:
                         Storage: AFF 300, ONTAP9.7
                         Switch: catalyst-6513
someone ?? please

[maffo]

if you set up VLANs on the controller side, on the trunk ports on the switch you need to allow at least the tags used on the storage side.

[joao2019]

                    In Switch Side:

I configured to allow all tags. unsuccessful
I configured to allow specific tags. unsuccessful

[joao2019]

                                             The configuration on the Switch side

Core cisco WS-C6513 

interface TenGigabitEthernet1/9/4

description Ligacao NETAPP AFF

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,2,4,16,20,25,40-44,70,71,101,102,220,225,332

channel-protocol lacp

channel-group 100 mode active

!

interface TenGigabitEthernet2/9/4

description Ligacao NETAPP AFF

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,2,4,16,20,25,40-44,70,71,101,102,220,225,332

channel-protocol lacp

channel-group 100 mode active

[Mjizzini · Accepted solution]

Are the ports going into s - suspended state?

As a test, try to run the command no port-channel standalone-disable on the port-channel interface. You will need to bounce the port-channel interface.