Active IQ Unified Manager Discussions

FAS2240-2 root aggr change

EFARNSWORTH
5,436 Views

I just got a new 2240-2 with dual controllers. the Ontap 8.1 setup on them has the 24 disks split evenly between the two controllers. I want to change it so that the secondary only has 4 disks, 2 for DP, 1 data 1 spare. Then add the other disks to controller 1 for all of the primary work. Problem is the OnCommand won't let you change anything on the root, and I'm not sure about the CLI commands to do it from there.

Can anyone help out with this so I can get the storage up and running.

Thanks, Erik

1 ACCEPTED SOLUTION

scottgelb
5,436 Views

we can't remove drives from an aggr, so you need to destroy the aggregate... special boot menu then option 4a boot to zero and create a 3 drive root then you will have 9 spare disks... unless you have another disk shelf to move root, then zero the drives with the system up.

View solution in original post

6 REPLIES 6

scottgelb
5,436 Views

To unassign 8 disks from one node and assign them to the other..

node2

priv set advanced

aggr status -s        # choose 8 of the disks

disk remove_ownership -f x.1 x.2 x.3 x.4 x.5 x.6 x.7 x.8

node1

disk assign all

EFARNSWORTH
5,436 Views

Its the root vol and aggr so the controller wouldn't let me do that??

scottgelb
5,436 Views

Is the root aggr 3 drives or did you add disks to it?  If you left it at 3 drives you will have 9 spares..

aggr status -s will show that... also aggr status -r to see the raid group layout

EFARNSWORTH
5,437 Views

The setup split the shelf 50/50 for the 2 nodes in the very beginning. The root aggr is 11 drives.

scottgelb
5,437 Views

we can't remove drives from an aggr, so you need to destroy the aggregate... special boot menu then option 4a boot to zero and create a 3 drive root then you will have 9 spare disks... unless you have another disk shelf to move root, then zero the drives with the system up.

EFARNSWORTH
5,437 Views

Thanks Scott,

I had to zero out the drives and reset the system back to factory to get the drives in the configuration that I wanted.

Public