Hi,
I have a hourly schedule in SMO at hh:30 and an hourly schedule in PM at the hour to protect the smo backup. Sometimes, the protection job fails with a ndmp error but it usualy works.
After the step of setting the snapshot name at source (ex: Set source snap to 'smo_smoasm_f_h_xxxxxxxxxxxxxxxxxx), the next step fails with
Source: netapp2:/SMO_DATA/-
Destination: netapp12:/SMO_DATA/dfpm_qtree_73_1938_1945
Bytes Transferred: Unkwown
Error Message:netapp12.de.lan:Couldn't authenticate NDMP connection to host 10.68.123.161
10.68.123.161 is the IP address of netapp12
netapp12> ifconfig -a
e0M: flags=108042<BROADCAST,RUNNING,MULTICAST,TCPCKSUM> mtu 1500
ether 00:a0:98:0d:e2:b2 (auto-unknown-cfg_down) flowcontrol full
e0a: flags=948043<UP,BROADCAST,RUNNING,MULTICAST,TCPCKSUM> mtu 1500
ether 02:a0:98:0d:e2:b2 (auto-1000t-fd-up) flowcontrol full
trunked vif0
e0b: flags=948043<UP,BROADCAST,RUNNING,MULTICAST,TCPCKSUM> mtu 1500
ether 02:a0:98:0d:e2:b2 (auto-1000t-fd-up) flowcontrol full
trunked vif0
lo: flags=1948049<UP,LOOPBACK,RUNNING,MULTICAST,TCPCKSUM> mtu 8160
inet 127.0.0.1 netmask 0xff000000 broadcast 127.0.0.1
ether 00:00:00:00:00:00 (VIA Provider)
vif0: flags=948043<UP,BROADCAST,RUNNING,MULTICAST,TCPCKSUM> mtu 1500
inet 10.168.123.61 netmask 0xffffff00 broadcast 10.168.123.255
partner vif0 (not in use)
ether 02:a0:98:0d:e2:b2 (Enabled virtual interface)
nfo enabled
netapp12> options ndmpd
ndmpd.access all
ndmpd.authtype challenge
ndmpd.connectlog.enabled off
ndmpd.enable on
ndmpd.ignore_ctime.enabled off
ndmpd.offset_map.enable on
ndmpd.password_length 16
ndmpd.preferred_interface disable (value might be overwritten in takeover)
ndmpd.tcpnodelay.enable off
netapp12> options snapmirror
snapmirror.access host=netapp2,netapp1,netapp1.de.lan,netapp2.de.lan
snapmirror.checkip.enable off
snapmirror.delayed_acks.enable on
snapmirror.enable on
snapmirror.log.enable on
snapmirror.readahead 0 (value might be overwritten in takeover)
snapmirror.readahead_freq 0 (value might be overwritten in takeover)
snapmirror.vbn_log_enable off (value might be overwritten in takeover)
and ndmp credentials are set correctly in Ops Mgr (both netapp2 and netapp12 are seen OK for System status, Login Credentials, NDMP status and NDMP credentials in the Management Console).
Thanks
Bruno
