All, a couple of my workflows have started exhibiting strange behavior. When executing or previewing the workflow, the first command box (no-op for CDOT) does not display. There is just a white box - the rest of the commands go blue and then green.
This was working fine until recently. What would cause this behavior?
The first command was named "test" as I was developing. When it was ready, I created a new command and pasted in the code.
I then added the command to the workflow (while the original "test" command was still there. In the workflow design, I edited the new command to reference the same variables (so I wouldn't lose the user input configs), and then deleted the "test" command.
I think by doing this I must have broken something internal to the workflow.
It is not just the 1st command only - just had one workflow command box show blank in middle of workflow as well. Checking execution, it says it ran, but there is no way to check within the box to see values.