add new disks

[8_5MARKMK]

Hi

We added new shelf and new disks were detected but I cannot create aggregate from system Manager. What I'm missing?

[RPHELANIN]

those disks belong to the partner controller so you need to create the aggregate from there.

[8_5MARKMK]

Sorry that are not disks what I was looking for. I have 24 SAS ones and console says UNOWNED. How configure owner of disks? Can I have both controllers for HA not just one owner? What state should show in case of both controllers have access to it? Data?

[8_5MARKMK]

disk assign all should be enough right?

[RPHELANIN · Accepted solution]

Run disk show –n beforehand to make sure that the only unassigned disks

are the new ones.

Then once your happy run disk assign all as you stated, just make sure

you run it form the controller you want to own the disks.

From: 8.5MARKMK

Sent: 20 May 2014 10:02

To: Ronan Phelan

Subject: - Re: add new disks

<https://communities.netapp.com/index.jspa>

Re: add new disks

created by 8.5MARKMK <https://communities.netapp.com/people/8.5MARKMK>

in *OnCommand

System Manager* - View the full

discussion<https://communities.netapp.com/message/130620#130620>

disk assign all should be enough right?

Reply to this message by replying to this email -or- go to the message on

NetApp Community <https://communities.netapp.com/message/130620#130620>

Start a new discussion in OnCommand System Manager by

email<discussions-community-productsandsolutions-datastoragesoftware-storagemanagementsoftware-oncommandsystemmanager@communities.netapp.com>or

at NetApp

Community<https://communities.netapp.com/choose-container.jspa?contentType=1&containerType=14&container=4092>

[8_5MARKMK]

Thanks guys all done and running.