Let's talk about Backup and Recovery! Engage with other data protection experts about NetApp's SnapManager, SnapDrive, SnapProtect and SnapCenter, Ransomware Protection, etc.
Let's talk about Backup and Recovery! Engage with other data protection experts about NetApp's SnapManager, SnapDrive, SnapProtect and SnapCenter, Ransomware Protection, etc.
In the case of a multi-node XCP configuration, can a node with the master role also be used as a worker? For example, xcp copy --nodes master,worker1,worker2 source:/vol dest:/vol
... View more
The completion time for XCP Verify varies greatly depending on the options. With "-l,-v" the comparison takes about 30 minutes, but with "-stats" it takes 7 minutes. With "-l,-v" the "Stats" section shows "1.07M scanned, 1.07M indexed, 43 giants, 100% found (995,259 have data), 995,259 compared, 100% verified (data, attrs, mods)". With "-stats" the "Stats" section shows "2.14M scanned". Can I understand that "-stats" does not compare the data?
... View more
I am trying to run an NDMPcopy to backup 2 volumes from a 7-mode system to a CDOT SVM of the same name. We were using snapmirrors and realized we updated out of a version that allowed us to do so. We ran: node run -node nodeName priv set advanced ndmpcopy -d -sa ndmp:XXpasswordXX -st md5 -da ndmp:XXpasswordXX -dt md5 sourceIP:/vol/vol1 destinationIP:/svm/vol1 The problem is both destination volumes do not match the source volumes in size. Vol1 is too small Source: Vol1 = 30GB Destination: Vol1=500MB Vol2 is too big Source: Vol2=2TB Destination: Vol2=5.5TB Why is there such a mismatch in both directions? Additional info: We did have some issues figuring out the ndmpcopy command on the first few runs. Each time it ran with an error it would still start and give the number of its run. Ndmpcopy: starting copy [9] This number increments each run even when we change the source and destination volumes between vol1 and vol2
... View more
IN ONTAP From DC-DR there is a Volume level replication is there. While creating a JOB i selected the Source SVM and Destination Side SVM with respective Volumes. After the JOB created in DR side Replication tab Source Side Name is Showing differently. For EX:- Source SVM name is SVM_X IN DR replication TAB Source is Showing like SVM_X.1 in cli that SVM_X.1 is in under peer vserver how this peer vserver is created.
... View more
Good afternoon, we are trying to upgrade several instances of Snapcenter Server 5.0 to 6.1P1 and do a clean install of 6.1P1 on a new server. we keep running into the following error message: 'Package SMCoreError: Service 'Snapcenter SMCore Service" failed to start. Verify that you have sufficient privileges to start system services'. the server we are installing on is Windows Server 2022. we have installed the MS .net requirements and are in the administrators group so i know its not a privileges issue. Has anyone run into this and come up with a resolution? there is a kb i found but following this we are still getting the same msg during installation. https://kb.netapp.com/data-mgmt/SnapCenter/SC_KBs/SnapCenter_6.0_installation_fails_Unable_to_start_SMCore_service
... View more