Hi all, I need to move our  Netapp FAS2650 Storage system to New datacenter in a Different State.  This will require a new subnet and subsequent re-IP'ing of ALL Network Interfaces. We also have Rubrik for NAS share backups (Rubrik uses its own Data LIF added as Host to backup and recover) and NDMP node directly cabled to NetApp (for legacy Avamar restores) . Our NetApp is used for CIFS shares (user, office shares) and is on ONTAP 9.7P7   Could someone please guide me on the proper steps to complete this move - from labeling all cables, graceful shutdown, physical move, start up? and where does the re-IP'ing occur, before or after the move? And anything else I may be overlooking?   I found the docs for shutdown and startup (listed below) so it looks like the physical move may not be too bad (knock on wood!) however my main concern is the Need to re-IP ALL Network Interfaces.   Thank you all for any and all input you can provide!!   docs: https://kb.netapp.com/Advice_and_Troubleshooting/Data_Storage_Software/ONTAP_OS/What_is_the_procedure_for_graceful_shutdown_and_power_up_of_a_storage_system_during_scheduled_power_outage https://kb.netapp.com/Advice_and_Troubleshooting/Data_Storage_Software/ONTAP_OS/How_to_power_up_all_ONTAP_nodes_in_a_cluster_following_a_graceful_shutdown   ... View more

Hi, Trying to to see Top Volume latency from QoS and I am getting this error  You must enable the Workload/QOS counters in $HARVEST/conf/zapiperf/default.yam   I have enabled it but still getting the error Restarted the instance but no luck. Any clues?   Thanks ... View more

Hi,   Recently I will install a Fas 2750 in switchless mode without any disk shelf, the equipment does not include mini SAS cables for connection between controllers.   My question is about whether there will be any effect on failover performance, if a controller fails? ... View more

Hello,   We are using Trident and we would like migrate data from one Kubernetes cluster to another.  We can do this using the command "import volume" from trident,  but is not compatible with the driver we use "ontap-nas-economy".  Do you know if this driver is planned to be supported for migrations? Is there another migration solution?     ... View more

Hi,   I have installed ActiveIQ config advisor version 6.5 on windows but it doesn't seem to start. I get a small dos box but when it disappear nothing happens.   I have tried manually to go to https://localhost:8445 and I get an error   can someone help me please??   yves ... View more