node run to get to the node shell, then priv set diag.
cmode-single::> node run local
Type 'exit' or 'Ctrl-D' to return to the CLI
cmode-single-01> priv set diag
Warning: These diagnostic commands are for use by NetApp
Thank you for the reply. I am trying to write a script
1. which would login into the node of the CDOT filer's to get the registry value for the auto-grow trigger which based on the size. ( For more Info https://kb.netapp.com/support/index?page=content&id=3011632&actp=search&viewlocale=en_US&searchid=null) .
2. If i don't have the desired value, the script would go and change it.
Ok, so you would just need to use the cmdlets Get-NcVolAutosize and Set-NcVolAutosize. Is this the data you are looking for (I'm just looking at one volume below as an example)?
#7 PS2 D:\Development\PowerShell> Get-NcVolAutosize -VserverContext vs-vmware -Name test | fl *
NcController : den-cluster
Name : test
IsEnabled : False
IncrementSize : 10485760
MaximumSize : 251658240
MinimumSize : 209715200
GrowThresholdPercent : 85
ShrinkThresholdPercent : 50
Mode : off
Thanks again. I think you are using 8.2 version ONTAP . But in 8.1 version cluster ONTAP , the autogrow would trigger based on the registry value we set @ the node level . which i am trying to modify