I am trying to have two basic functions: to query a given quota and to modify that same quota.
However, the resulting output does not seem to match
If I run the query command [GET-NCQUOTAREPORT] it returns this value.
QuotaType QuotaTarget Volume Qtree DiskUsed FilesUsed Vserver
--------- ----------- ------ ----- -------- --------- -------
tree /vol/test/test test test 8 3 vserver1
If I query it differently [GET-NCQUOTA] I get this returned:
QuotaType QuotaTarget Volume Qtree DiskLimit FileLimit Vserver
--------- ----------- ------ ----- --------- --------- -------
tree /vol/test/test test 1048576 1048576 - vserver1
If I modify [SET-NCQUOTA] the console output is the following:
QuotaType QuotaTarget Volume Qtree DiskLimit FileLimit Vserver
--------- ----------- ------ ----- --------- --------- -------
tree /vol/test/test test 1048576 - vserver1
QuotaTarget : /vol/test/test
Qtree : test
DiskUsed : 8
DiskLimit : 5120
As you can see the value of disk limit differs between the two. Why is this and how can I adjust the query/modify commands so that it reflects the correct disk limit information which shows correctly when viewing the disk limit in the GUI interface?
