Network and Storage Protocols

AFF C800 - RDMA RoCE on LACP portgroup “A broadcast domain with RoCE-capable ports wasn't found”.

crisnetapp
2,237 Views

I have a Netapp AFF C800 system with several network interfaces including 2 x 25Gbps 2-port cards. These 25Gbps ports are seen by Ontap as RDMA RoCE enabled.
I created a LACP (IP based) portgroup by taking the first port of each of the 2 cards inside each controller.
On the LACP portgroup a0a, the RDMA Protocol column no longer shows the RoCE entry as it did for the individual boards.
When I go to create a LIF of type Data - NFS, SMB/CIFS and check the “Use RoCE ports” checkbox, I get the error message “A broadcast domain with RoCE-capable ports wasn't found”.
So my question is this: is it possible to use RoCE on a LIF if Link Aggregation Groups are created? If so, how should I create the LAG in order to have RoCE? Or do I have to do it completely differently e.g., by not creating the lag?

 

Thank you

 

1 ACCEPTED SOLUTION

AlexDawson
1,760 Views

https://docs.netapp.com/us-en/ontap/nfs-rdma/index.html - "Interface groups are not supported with NFS over RDMA."

 

This will be the issue.

 

Sorry!

View solution in original post

2 REPLIES 2

AlexDawson
1,761 Views

https://docs.netapp.com/us-en/ontap/nfs-rdma/index.html - "Interface groups are not supported with NFS over RDMA."

 

This will be the issue.

 

Sorry!

crisnetapp
1,453 Views

Thank you Alex.

Best regards

Adriano

Public