ONTAP Discussions

Highlighted

Cannot see CL snap morrow on the source

When I run "snap morrow show" on the destination filer, there is no issue and I can see multiple DP relationship. Howeve, can not see any on the source filer

What could be the reason?
Thanks!
4 REPLIES 4
Highlighted

Re: Cannot see CL snap morrow on the source

use "snapmirror list-destinations" instead.
Highlighted

Re: Cannot see CL snap morrow on the source

Yes, this command works.

 

However, why "snapmirror show" on the source filer is not working? Should not it be working as well?

Highlighted

Re: Cannot see CL snap morrow on the source

As noted here, "snapmirror show" only shows destination info in CDOT. This should not work on source side.

https://library.netapp.com/ecmdocs/ECMP1511539/html/snapmirror/show.html


I'm not sure why NetApp makes change in CDOT, but this is expected heavior.

View solution in original post

Highlighted

Re: Cannot see CL snap morrow on the source

Well, I used to work on an older version of CDOT, snapmirror show on the source gave me the destination infor as well, not sure what reasons behind it chnaged on the newer version of CDOT

THANKS!

Check out the KB!
Knowledge Base
All Community Forums