Hi everyone,
I am trying to rebuild two old Data OnTap devices. I replaced all the disks and the devices currently won't boot, which is fine.
I thought I would Ctrl+C during boot-up and then select option 4 to Initialise the disks, but when the menu comes up, I go to press option 4 and hit enter and it won't accept any input. The only option I have is to power off the device and try again. When I press the power button, the console connection shows that I have powered down, so it hasn't hung it just not accepting my inputs at that point. The console connection is definitely working as I am able to press Ctrl+C and I also reinstalled the firmware for the device through the console.
Any ideas? I was wondering if it was my terminal settings maybe? I am using:
Bits Per Second - 9600
Data Bit - 8Bits
Parity - None
Stop Bits - 1
Flow Control - Hardware
Emulation - VT100
Thanks,
David
