Solved: FAS8020 Converted to CDOT and Upgraded to OnTap 9 - Missing e0c and e0d Ports

dartfordbc · ‎2017-01-17

Hi

We have zeroed our FAS8020, converted to clustered, upgraded to OnTap 8.3 from 8.2.4 and then upgraded to OnTap 9.1

Previously we didn't have an Cluster Interconnect as it was 7 Mode. I used e0a and e0b fibre ports to interconnect. I want to use e0c and e0d on each node for my data network but they do not show in OnCommand management and they do not show when I do ana ifconfig -a

I can't find anything on the internet about it.

Please help.

SeanHatfield · ‎2017-01-17

First guess, the ASIC is in FC mode.

Try:

system node hardware unified-connect show

If so you have to put them in cna mode with

system node hardware unified-connect modify

Then reboot each node.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

View solution in original post

asulliva · ‎2017-01-17

What do the commands "net port show" and "net int show" report?

Andrew

If this post resolved your issue, please help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

SeanHatfield · ‎2017-01-17

First guess, the ASIC is in FC mode.

Try:

system node hardware unified-connect show

If so you have to put them in cna mode with

system node hardware unified-connect modify

Then reboot each node.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.