Solved: Re: FCoE Direct Connection From Server to Filer

SCOTT_V_RONTALE · ‎2015-10-11

Hi ,

Why is that the other network ports from the server gets disconnected when the port of FCoE from FAS2552(directly connection to server) gets UP.

Thanks,
Scott

scottgelb · ‎2015-10-19

That would work but when you have a failover event, the all of the IP addresses will move to the HA-Partner in 7-Mode and you would lose connectivity to the lun. If cDOT, the IPs (LIFS) would not move and MPIO with ALUA is required. I wouldn't direct attach any SAN protocol (not supported for cDOT). With FC it is supported direct attached (7-Mode ONLY, as long as native FC connected to both controllers in the ha-pair), but I don't like that setup...always prefer multipath across two switches.

View solution in original post

Sahana · ‎2015-10-12

Hi

The host FCoE initiator must connect to an FCoE DCB (data center bridging) switch; direct connection to a target is not supported. Refer page 23 on the SAN configuration guide: https://library.netapp.com/ecm/ecm_download_file/ECMP1518989

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

SCOTT_V_RONTALE · ‎2015-10-19

HI Sahana,

Thank you for the information but i want to clarify something , What If we use a cable for ISCSI that is 10g and remove the SFP? Would it be possible or does it support that kind of setup having direct connection to server.

THank you!

scottgelb · ‎2015-10-19

That would work but when you have a failover event, the all of the IP addresses will move to the HA-Partner in 7-Mode and you would lose connectivity to the lun. If cDOT, the IPs (LIFS) would not move and MPIO with ALUA is required. I wouldn't direct attach any SAN protocol (not supported for cDOT). With FC it is supported direct attached (7-Mode ONLY, as long as native FC connected to both controllers in the ha-pair), but I don't like that setup...always prefer multipath across two switches.