ONTAP Discussions

How do we know controller is running in cifs or nfs protocol?

newbeee
6,088 Views
As per topic
5 REPLIES 5

JGPSHNTAP
6,085 Views

7-mode or cdot.. Check the services  

newbeee
6,071 Views
i know those modes but which services should I check?

JGPSHNTAP
6,068 Views

If you are running cdot

 

cifs show

nfs show

 

newbeee
5,933 Views
How about 7 mode?

Renifa
5,851 Views

In 7 mode, use” nfs show” command to check the status of the NFS service.

For CIFS you can use to command “cifs shares”  If CIFS protocol is enabled it will display all the shares however if it’s not enabled it will give you a message “CIFS not running” 

Similarly if you type the command “cifs ? “ it will give you the commands associated to CIFS however if CIFS protocol is not running than it will give you a message “CIFS not running”

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.
Public