Multi Tenancy Management Question

[STORMNETAPP]

Hi,

Hopefully quick question regarding filer management in a multi tenancy scenario.

We may be looking to migrate from an EMC Celerra to a Netapp filer.  i've got a copy of the Data Ontap 8.0.1 simulator and have been running some tests to ensure a netapp filer can provide the same features we are used to and that we can present data via a netapp filer.

All was going well, I can create multistore vfilers with DR failover using ipspace,vlans in different configs.

However looking at the management side am I right in saying that management access both cli and gui, that the ipaddress and ethernet port used must reside in the default-ipspace ?

We have four ports per controller so I was thinking that each company would have two ethernet ports in a vif, with vlans in their own ipspace.  But I can't move vfiler0 into a non default ipspace therefore this configuration would not work ?

Any sugggestions how I can allow management access from both companies yet keep each companies traffic separate ?

Any advice or help greatly appreciated

[scottgelb · Accepted solution]

If you are not running FCP, you can put only e0M (100MBIT management interface) and vol0 in vfiler0 and the default-ipspace.  vfiler0 and the default-ipspace cannot be changed but you can assign the minimum root and e0M to it... then for all other data assign to vFilers. 

[STORMNETAPP]

Thank you for your reply Scott and confirming where vfiler0 must reside

As I have been using the simulators I hadn't realised there was a separate management port on a physical device. 

This should allow us to accomplish our aims in that Site A where one Filer is located we can use the management port if they are in a non default ipspace. Whilst Site B can use the default ipspace.  All client traffic from both sites would then be routed independently.

Just to clarify one quick point if I may. You mention regarding FCP we have no fibre connected hosts yet, but I imagine we will at some point. Are you saying that any FC attached host can manage the filer ?

[scottgelb]

I replied via email but that is broken now and doesn't post...  

FCP can only run in vfiler0... so FCP LUNS can't be in a vfiler other than vfiler0.  The FCP host isn't for management... e0M can be used to manage the system via ssh, system manager, etc...

[STORMNETAPP]

Excellent Thanks for clearing that up.

[scottgelb]

Fcp is not supported in vfilers exept vfiler0 so fcp lus have to be in vfiler0.

Actual management is separate from fcp.

Typos Sent on Blackberry Wireless