ONTAP Discussions

Highlighted

Node Name set to Multiple Values in Disk And System Performance Commands

When I run statistics command against Disk object, I see the below output for few Disks where node_name is set to Multiple Values, while for Others it displays the correct node name to which the Disk is associated.

Object: disk
Instance: x.x.x
Start-time: 3/19/2020 23:21:57
End-time: 3/19/2020 23:21:58 
Elapsed-time: 1s
Scope: xxxxxxxxxx

    Counter                                                     Value
    -------------------------------- --------------------------------
    cp_reads                                                        3
    disk_busy                                                      0%
    guaranteed_read_blocks                                          0
    guaranteed_write_blocks                                         0
    node_name                                         Multiple_Values

 How can I get to know to which Disk is the node associated?

1 REPLY 1
Highlighted

Re: Node Name set to Multiple Values in Disk And System Performance Commands

Weird. Do you have a support case open? That's bizarre.

Check out the KB!
Knowledge Base
All Community Forums