ONTAP Discussions

Service Processor

MohitChordia
4,561 Views

1) On which port does service processor interface/LIF is configured ?

2) Is there any physical connectivity for SP( Service Processor) to network switch ? I dont see any port assigned for SP when i check "network interafce show".

3) If there is no connectivity how SP/RLO get IP assigned ?

4) We have to modify the IP address of SP interface as we are changing the network switch ?

3 REPLIES 3

Damien_Queen
4,548 Views

1) IP for SP configured on dedicated wrench port. Usually, it looks like a wrench symbol.

2) which switch you are talking about? Usually, SP connected to the management switch

3) you can use DHCP or configure IP & GF for SP manually

4) I do not see such need

MohitChordia
4,535 Views

1) I dont see SP configured on any of the ports such as ( e0M , e0a,b,c,d,e,f) . What is the port name and with which command i can check that ?

 

2) Iam asking is there any physical connectivity for SP from netapp array to network switch , similar to what we have for node management or data ports.

 

Regards,

Mohit

Damien_Queen
4,521 Views

 

1)

cluster1::> system service-processor network modify -node local -address-family IPv4 -enable true -ip-address 192.168.1.202 -netmask 255.255.255.0 -gateway 192.168.1.1

2) I do not understand what switch connectivity you are talking about. Usually, e0M & SP (wrench port) living on a single physical port but have two different MAC addresses. And usually, wrench port connected to dedicated management network switch or at least management network VLAN.

 

 

Public