Hi all, below is how we have set up our vscan per vfiler:
Virus scanning is enabled.
This vfiler is configured to use vscan servers connected to the host filer.
Secondary scanners IP address list:10.105.130.101,10.105.130.102,10.105.130.103
robvfiler@filer1> vscan optionsvscan options timeout: 10 secvscan options abort_timeout: 10000 secvscan options mandatory_scan onvscan options use_host_scanners onvscan options client_msgbox off
we aere advised that with this 'on': vscan options mandatory_scan on
All our vfilers would use vfiler0 as a gateway so causing performance issues.
However, after turning it off - I don't have any scanners attached
vscan options use_host_scanners off
No vscan servers are connected.
I don't see a way to add primary scanner to a vfilers - synatax below. Can anyone help? thanks Rob
vscan scanners [stop scanner-IP-address | secondary_scanners [ scanner-IP-address [, scanner-IP-address ]]]
First, let me give you some advice. NEVER EVER EVER NEVER EVER NEVER use mandatory scan on. You are asking for problems.
Also, your abort timeout is set wrong. It should be 40seconds and you should work with your a/v team to confirm theirs is 50seconds.
Also, we only configure the vscan at the host layer and then refence the option below
vscan options use_host_scanners on
Hi, mandatory scan is actually off for for our production vfilers - this vfiler is not in use but thanks.
I will also check the abort timeout - again inherited - thanks.
However, does anyone know of a way to configure vfilers to use vscan scanners directly?
Support advised that using them at the host level (vscan options use_host_scanners on) was a bottleneck through vfiler0.
The NetApp Support Site won an Association of Support Professionals Best Support Website in 2022 award.
Live Chat, Watch Parties, and More!