ONTAP Discussions

Vserver migrate feature

gfz-marco
4,822 Views

Hello

 

We want to migrate some vservers on our 4node metrocluster to even out load and volume/aggregate usage but when doing a
"vserver migrate start -check-only true -vserver ......." we get an error stating that "Vserver migrate feature must be enabled".

Question is, where can we find this feature and if its licensed or not?

Is it part of some package or other license?

 

Any help woud be much appreciated

 

Regards

Marco

1 ACCEPTED SOLUTION

paul_stejskal
4,700 Views

You can get license keys from your account team. You can run the license show as well to see what is ran.

 

I don't believe it is on the ActiveIQ portal.

 

View solution in original post

5 REPLIES 5

GrumpyOldMen
4,747 Views

Cannot find either stuff about this. But where are you committing the command? On the new destination or on the source? Should be on the destination.

gfz-marco
4,731 Views

@GrumpyOldMen 

From the destination, to "pull" the svm to it.

 

@moep 

System looks like this:

node1-1 (this is where the svm is now)

node1-2

node2-1

node2-2 (this is where we want to move the svm to)

 

Even though this might not be possible, it still begs the question on where to find the feature/license ...

paul_stejskal
4,701 Views

You can get license keys from your account team. You can run the license show as well to see what is ran.

 

I don't believe it is on the ActiveIQ portal.

 

cruxrealm
4,418 Views

What exact license is needed?    Apparently, Netapp support does not know after calling it in and asking multiple times.

moep
4,741 Views

You cannot migrate between the two "halfs" of a MetroCluster afaik.

Public