cDOT CLI >igroup show

[tyrone_owen_1]

Hi

In 7-mode you can run the igroup show -v command and see which target port an initiator is logged in on. Is there an equivalent command in cDOT?

Thanks

[marcusgross]

Hi,

you can always use

-instance

in the command line to get more output.

M.

[tyrone_owen_1]

Thanks, I know about the -instance switch. My question was about running a command which shows which target port an initiator is logged into, the -instance switch doesn't show this.

[aborzenkov]

You can use "iscsi initiator show" to list initiators and target portals they are logged into and "iscsi interface show" or "iscsi portal show" to match portals and interfaces.

[tyrone_owen_1]

Thanks for the reply.

I guess that works fine for iscsi initiators but not fibre channel initiators.

Thanks

[aborzenkov · Accepted solution]

E-h-h ... what's wrong with "fcp initiator show"?

[tyrone_owen_1]

Nothing wrong with 'fcp initiator show' as long as you know the command exists - thanks