vol status -v on Ontap8.01 missing autosize settings output!

[syscare_support]

I am trying to get the autosize information for all of my volumes on Ontap8.01

In Ontap7.3.x If I ran vol status -v I got the following output at the bottome of each volumes information:

Volume autosize settings:
                                state=on
                                maximum-size=180 GB
                                increment-size=7680 MB

In Ontap8.01 this information is no longer there!

Is there a new command? I realise I can run this per vol using the vol autosize command but I want an output for all my volumes from one command.

[chriszurich]

Interesting, I just obeserved the same issue.  I wonder if NetApp could fix this within a service pack.  You would think that -v output would include ALL information about a volume. 

[paul_wolf]

I'm running 8.0.1P3 and I see the same issue. No autosize information is shown.

[jakob_bena]

hi,

i have installed on a filer ONTAP8.0.2. there is the autosize information available.

regards