I doing some changes/configurations on this FAS2020 using setup conmmand the issue is every time a reboot one of the filer is stuck at this menu:
(1) Normal boot.
(2) Boot without /etc/rc.
(3) Change password.
(4) Initialize owned disks (6 disks are owned by this filer).
(4a) Same as option 4, but create a flexible root volume.
(5) Maintenance mode boot.
the other filer boots up ok
what could be the issue?
thanks a lot
no worries guys
I fixed it..... I went into Maintenance Mode (5)
and run boot_primary boot OK after that I run again reboot and boots up OK like filer2
This normally happens when filer cannot find its root volume. If you post full log from turning power on until this menu appears, someone may be able to tell what happens.
Let's walk you through the new & improved Knowledge Base and further enrich your experience with NetApp Products.
Join our Discord Community