Solved: V-Filer dr configure error

kobusventer · ‎2017-04-14

Hi Guys and Ladies

I have to configure a DR v-filer but get the following error in doing so - knowledgebase and support site does not give me any info.

vfiler dr configure source_vfiler@source_filer -u
source_filer's Administrative login: root
source_filer's Administrative password:
source_filer: Connection refused
vfiler command cannot be run while 'vfiler dr' command is running; try again later.
: Undefined error: 0

Can someone please tell me why I am getting this error, and what I should do to get around it?

Regards

georgevj · ‎2017-04-16

Enable and configure rsh on both source and destination, then retry.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.
Cannot find the answer you need? No need to open a support case - just CHAT and we’ll handle it for you.

View solution in original post

georgevj · ‎2017-04-16

Enable and configure rsh on both source and destination, then retry.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.
Cannot find the answer you need? No need to open a support case - just CHAT and we’ll handle it for you.

kobusventer · ‎2017-04-16

Hi, thanks for the feedback - however, rsh is enabled on both filers. By the way - I am running DOT 8.2.3P2.